Hub and Spindle Assemblies
SuperLube Wheel Hub/Spindle Operating Instructions
Your trailer is equipped with TDE wheel hubs/spindles. The hubs are pre-greased and assembled at the factory and should not require any initial adjustments. The UHI hub uses tapered roller bearing cones and cups. This configuration requires a minimal amount of end play that is provided at the time of assembly.
SuperLube Lubrication
Your hub/spindle is equipped with TDE's SuperLube Lubrication System. The bearings can be periodically lubricated without removing the hubs from the axle. The advantage to this system is that new grease saturates the inner bearing and outer bearing while pushing out the old grease, unlike systems that just push new grease on top of old grease.
1. Remove the rubber plug from the grease (hub) cap.
2. Use a standard grease gun onto the grease fitting located at the end of the spindle, or behind the hub, making sure the grease gun nozzle is engaged on the fitting tightly.
3. Pump grease into the fitting, while slowly turning the wheel. Grease will flow out of the hub around the spindle.
4. When the grease appears to be the new clean grease, remove the grease gun and wipe off any excess grease.
You might also like
![]() |
Brand New Front Wheel Hub and Bearing Assembly Escalade, Express, Savana, Sierra, Yukon 6 Lug W/ ABS 4WD Automotive Parts and Accessories (Detroit Axle)
|
![]() |
Brand New Front Wheel Hub and Bearing Assembly 97-01 Ford Explorer, Mercury Mountaineer; 01-05 Explorer (Only) Sport Trac 4WD 5 Lug W/ ABS Automotive Parts and Accessories (Detroit Axle)
|